Check out Hard Air Magazine!

08 May, 2010

Industry Brand Rear Field Sight on Crosman 1377 Pistol

Guest post from "My customer Craig".

As you may know, mounting an Industry Brand Rear Field Sight on the steel breech of a Crosman 1377 pistol results in a sight too high to be adjusted down to the target.

However, this "fix" gives great results for practically no money!



You simply (carefully) drill a 1/16-in hold straight down into the Crosman front sight and then insert a small piece of nail cut to length into the hole. Trial and error will allow adjusting elevation of the new set-up and the result is a pin-point sight arrangement that I find much better than stock Crosman plastic sights.

These photos show details.




Craig, thanks for sharing your project with us!

0 comments:

About This Blog

This blog shares information, ideas and knowledge about air rifles. It compliments the information Stephen publishes on the Archer Airguns website, on YouTube and the Chinese Airgun Forum.

  © Blogger templates The Professional Template by Ourblogtemplates.com 2008

Back to TOP